Porpoising problems with my bass boat? - bass boat props
I) a 1989 (old) bass boat (16.5 foot fiberglass with 90 hp outboard at half. The bullet hole takes forever and dolphin boat like crazy in the mid to higher speeds. Moreover, not all have opened the way because I only 2 pistons rebuilt, but it seems that my rpms are higher than they (5000, should not still open). No need to look, a hovercraft or other components which options to improve the performance could buy. Also, I do not know what happened to the top (black - aluminum?) Is it because the seal is too small to read in order to. Is there any way to know the propeller to measure what happens is he?
Monday, January 4, 2010
Bass Boat Props Porpoising Problems With My Bass Boat?
Subscribe to:
Post Comments (Atom)
5 comments:
Learning Drive
Learning Drive
Learning Drive
Learning Drive
If the hole is slow, or there is a problem with the V4 engine power is very low and should the boat from the water. or propeller must spend a lot of money. YU U Say you open the gas. Porpoising for 2 things 1 is responsible, the value of the motor is too high. Or is there a hook in the shell or integrated into the hull speed over 20 MPH, you push the bow down. A majority of vintage boats that in. It is a hull speed had 20 built "from the rear and a curve up and down. I glass bottom and the boat will run in the back half of the helmet. 5000 is not very high, say between 5600 and 5800 WOT.Depending in year.Don concern about the high-end u unless running all the time. Our new twin Suzuki 175 HP, we load limiter system 6000 rpm with a load, the 5800th But cruise in 4300 in freedom.
Post a Comment